Autoplane Technologies
Request a unit
Training  /  Phase 2

Phase 2 of 5

Primer

On cured primer-surfacer, use guide coat before the initial cut, check the contour with light diagnostic block passes, then refine for the next coating.

At the bench

The grit sequences below are provided as exemplary.

  1. Confirm cure and permitted sanding in the primer-surfacer TDS. Apply compatible guide coat before the initial cut. P400 on AutoPlane is one example where the coating system permits it.
  2. Reapply guide coat as appropriate and make light diagnostic passes with a P600 long block. Use long vertical, horizontal and diagonal passes only where the block contacts the intended contour appropriately.
  3. Stop and assess persistent marks rather than sanding until they disappear. Check for thin areas and breakthroughs before deciding how to correct the surface.
  4. Refine with P600 on AutoPlane and inspect the scratch pattern separately. Add P800 only if the next coating and abrasive specifications require it.

After sanded surfacer, use a compatible basecoat directly or a compatible sealer, its specified flash, then basecoat, as the coating TDS directs. Wet-on-wet sealer normally is not sanded within its application window; follow its TDS if correction or recoating is needed.

Example grits P400 → P600; P800 if required
Pressure Even, supported face
Passes Even and overlapping
Check Contour, scratches and film

What to look for

  • Guide coat used before the initial cut and for the diagnostic check.
  • The intended contour assessed without chasing persistent marks.
  • Scratch refinement and film condition suitable for the next coating, per its TDS.

What to avoid

  • Cutting through at edges, body lines or thin areas.
  • Treating P400, P600 or P800 as suitable for every coating system.
  • Treating wet-on-wet sealer like sandable primer-surfacer.

Follow the coating manufacturer's technical data sheet (TDS), abrasive instructions and the requirements of the next coating. Confirm cure, compatibility and permitted film removal before starting.