Training / Phase 5
Phase 5 of 5
Care and troubleshooting
When to replace the head, heat and aluminum, and the most common mistakes.
At the bench
- Inspect the foam, hook-and-loop attachment and bonded layers before use. Stop using a head that is cut, torn or delaminated.
- Use even, supported pressure and inspect between overlapping passes. Stop if the panel becomes hot or the head no longer behaves as expected.
- Clean and store the head according to its care instructions. Before the next job, recheck attachment, foam recovery and layer condition.
Clean Compressed air
Store Flat, off a hot tool
Replace Foam stops springing back
Heat Hot panel? Stop and cool
What to look for
- Foam springs back after each pass.
- The loop still grips your backing pad.
- Layers stay bonded at the edge.
What to avoid
- Soaking the head in solvent.
- Running it without abrasive on the face.
- Long cycles on aluminum without dust extraction.
Follow the coating manufacturer's technical data sheet (TDS), abrasive instructions and the requirements of the next coating. Confirm cure, compatibility and permitted film removal before starting.