Autoplane Technologies
Request a unit
Training  /  Phase 1

Phase 1 of 5

Filler

Shape cured filler toward the intended contour, use guide coat and a light long-block check to assess it, then refine the scratches before primer.

At the bench

The grit sequences below are provided as exemplary.

  1. Where the filler and abrasive instructions allow it, start with P80 on AutoPlane using even, overlapping passes that follow the intended contour.
  2. Apply compatible guide coat, then make light diagnostic passes with a P180 long block. Use long vertical, horizontal and diagonal passes only where the block makes appropriate contact with the intended contour.
  3. Stop and assess persistent marks. They can indicate shape or contact issues; do not keep sanding just to remove every mark. Choose the correction before continuing.
  4. Refine with P180 on AutoPlane. Check that the previous scratches are refined separately from the contour check. Add P320 only if the filler and next coating specifications call for it.
Example grits P80 → P180; P320 if required
Pressure Even, supported face
Passes Even and overlapping
Check Contour, then scratches

What to look for

  • The repair follows the intended contour, including its curves.
  • The guide-coat pattern is assessed after light diagnostic block passes.
  • The previous scratch pattern is refined to suit the next coating.

What to avoid

  • Forcing the head or bottoming out the foam.
  • Flattening an intended curve or tipping onto an unsupported edge.
  • Sanding until every persistent guide-coat mark disappears without assessing its cause.

Follow the coating manufacturer's technical data sheet (TDS), abrasive instructions and the requirements of the next coating. Confirm cure, compatibility and permitted film removal before starting.