Autoplane Technologies
Request a unit
Training  /  Phase 3

Phase 3 of 5

Clear

On cured clear, choose the least aggressive suitable starting grade and control film removal. Refine scratches, then use the approved buffing and polishing system.

At the bench

The grit sequences below are provided as exemplary.

  1. Confirm the clear is cured for sanding and has sufficient usable film under the coating manufacturer's requirements. Inspect edges, body lines and thin areas. If permitted film removal is uncertain, stop and confirm the repair approach.
  2. Choose the least aggressive suitable starting grade. Where the coating and abrasive instructions permit, P1500 followed by P2000 on AutoPlane is one example.
  3. Use even, overlapping passes on supported areas and inspect between passes. Check texture and scratch refinement separately, while preserving the film required by the coating system. Do not use a long-block check on clear.
  4. Move off AutoPlane for 3000-grade or finer foam-backed refinement with the abrasive's specified backing and method. Then buff and polish as required by the approved finishing system.
Starting grade Least aggressive suitable
Pressure Even, supported face
Refinement 3000+ foam off AutoPlane
Check Texture, scratches and film

What to look for

  • Sanding allowed by the clear's cure and film requirements.
  • Controlled texture reduction with frequent inspection.
  • Previous scratches refined before the approved buffing and polishing steps.

What to avoid

  • Assuming every clear accepts the same sequence.
  • Chasing texture at the expense of required film, especially near edges.
  • Using a long block on clear or foam-backed 3000+ refinement on AutoPlane.

Follow the coating manufacturer's technical data sheet (TDS), abrasive instructions and the requirements of the next coating. Confirm cure, compatibility and permitted film removal before starting.