Autoplane Technologies
Request a unit
Training  /  Phase 4

Phase 4 of 5

Blending

Use controlled, overlapping passes to work toward the intended blend boundary. Match the abrasive and inspection method to the coating stage.

At the bench

  1. Check the intended contour and blend boundary before starting. Choose the abrasive sequence permitted for the coating stage.
  2. Keep the head supported, use even pressure and make controlled, overlapping passes. Inspect before extending the worked area.
  3. For filler and primer-surfacer, use compatible guide coat and light diagnostic block passes where appropriate. On clear, inspect texture, scratches and usable film without a long-block check.
Grits Match the coating stage
Pressure Even, supported face
Passes Controlled and overlapping
Check Use the phase guidance

What to look for

  • A controlled transition toward the intended contour.
  • A supported head throughout each pass.
  • Separate checks of the contour and scratch pattern for the phase.

What to avoid

  • Chasing a persistent mark outward without assessing it.
  • Forcing the head across tight curves or body lines.
  • Applying the filler or primer long-block check to clear.

Follow the coating manufacturer's technical data sheet (TDS), abrasive instructions and the requirements of the next coating. Confirm cure, compatibility and permitted film removal before starting.